Categories

Manufacturers

Heraeus Palamat Elite Polymerization unit

The legendary Heraeus Kulzer water-bath polymerization distinguishes itself through the best possible polymerization of denture acrylics. This process enables the smallest residual content of monomer and ideal mechanical properties.



More details

On sale On sale!
$1,200.00

Loyalty program By buying this product you can collect up to 120 loyalty points. Your cart will total 120 points that can be converted into a voucher of $60.00.


26 other products in the same category:

The Palamat elite Advantage

  • Polymerize up to 6 dentures at once
  • One unit to polymerize heat and cold cure acrylics
  • Overnight heat cure cycle
  • Rapid heat cure cycle
  • Virtually all sizes of flasks can be used
  • Completely automatic (Heater shut off/pressure release)
  • Extra deep water vessel

 The cuvette is placed in a minimum of 3 liters of lukewarm water and covered with water to the top. The water-bath is heated up to 70 degrees Celsius over approx. 30 minutes, and then kept at this temperature for a further 30 minutes. Subsequently the water-bath is brought to the boil over a period of approximately 20 minutes, and kept at this temperature for 30 minutes. To alleviate the tension after polymerization, the water-bath is cooled down slowly. Heraeus Palamat Elite Polymerization unit greatly improves the life expectancy and precision-fit of the denture acrylics. 

No customer comments for the moment.

Only registered users can post a new comment.